X5 Progress Report

So it’s been a few weeks now since I took ownership of the E53 X5. It’s been a busy time with travel for work and so I have not been able to get as much done as I had hoped. The car has been in the local garage a couple of times but has so far not had much done on it due to them being busy , holidays, etc.

Here’s what has been done so far:

  • The pixels in the dash have been fixed. This has allowed us to see the messages that were being displayed. This was Check Park Light and Check Reverse Light. After playing a little with the connections these have now stopped being displayed.
  • I knew the car needed a new front passenger tyre, ended up that it needed all four new boots.
  • The car has now had a service.
  • The steering wheel has been adjusted to that it is now straight. It’s amazing how annoying it is if the steering wheel is off, even by just a small amount.
  • No matter how much I tried to get the keys working, the one key to start the car and both keys to operate the remote central locking, I just couldn’t get them to work. I took the car down to Newhall BMW in Sheffield and the guys there were nice enough to plug in their computer and looked to see if they could get the keys working. They came to the same conclusion as me, the key is kaput. I went to Sytners and ordered a new key, two days later I have a new key that will start the car and will operate the remote central locking.
  • I have replaced the two tailgate lights. I did clean up the passenger side but I also managed to break it in the process. The drivers side has a crack in the reverse lens. I quick online chat with Quarry Motors in Sheffield and two replacement lights were on the way. These are really easy to replace with only three screws holding each in place. Remove the top plastic cover on the tailgate and then the inside plastic trim and the lights are easily accessible.
  • Plugged in the MID to try and get the BC to display messages in the instrument cluster. According to the manual this should be possible by pressing the BC button on the end of the stalk until the display shows PROG. Unfortunately I can’t get it to display PROG. I tried using INPA to program the display but no joy there either. All I want is to have the current time displayed in the cluster on the message line.

So what is left to do:

  • The drivers door actuator will be replaced this coming week at Newhall BMW(http://newhallsheffield.com/)
  • EML Light, Engine running lean on banks one and two. Hoping this is just a split pipe. Not spotted anything obvious under the bonnet.
  • Lights coming on now and again for the DSC and brakes. Looks like a wheel sensor. Shouldn’t be much to resolve.
  • Car does not get up to temperature. Thinking this is a stuck thermometer.
  • Handbrake replacement. The teeth are all worn and needs adjustment.

The car is back in the local garage again this week to have these remaining items looked at.

Looking forward to finally getting these last few things sorted and then the next thing is to look at the bodywork. The body work is not in to bad a condition (apart from the small dent in the tailgate I put in it last week after reversing in to a skip). Needs a good clean, clay, polish and wax. The thing now is finding the time at the weekends when it is not raining or blustery.

I am really enjoying playing with the X5 but I think the poor E39 is feeling a bit left out recently.

Leave a Reply

Your email address will not be published. Required fields are marked *